Role of Fracture Zones in Controlling Hydraulic Head and Groundwater Flow?Experience from Site Characterization Program in Finland
The preliminary site investigations for the final disposal of HLW produced by TVO have been carried out during 1987 - 1992 in five areas. All the areas consist of Precambrian crystalline...
Simulation of Fracture Flow to the Kamaishi Validation Drift
The Power Reactor and Nuclear Fuel Development Corporation (PNC) has developed an in-situ test facility in the Kamaishi Mine to resolve technical issues in disposal of radioactive wastes...
Scenario Development for Performance Assessment?Some Questions for the Near-Field Modelers
In an attempt to achieve completeness and consistency, the performance-assessment analyses developed by the Yucca Mountain Project are tied to scenarios described in event trees. Development...
Drift Emplaced Waste Package Thermal Response
Thermal calculations of the effects of radioactive waste decay heat on the potential repository at Yucca Mountain, Nevada, have been conducted by the Yucca Mountain Site Characterization...
Implications of Stability Analysis for Heat Transfer at Yucca Mountain
An analytical solution has been obtained to the stability problem for an infinite horizontal layer of gas with its humidity constrained to 100%. Latent heat transfer makes convective heat...
Modeling of the Ventilation for Emplacement Drift Re-Entry and Rock Drying
Different ventilation scenarios were analyzed for a hot repository with a 114 kw/Acre heat load, to determine the time required to cool a drift to the point where the temperature of the...
Discontinuities, Rock Deformation and Fluid Flow Around Emplacement Rooms
One of the major concerns for the design of the potential nuclear waste repository at Yucca Mountain is how to identify the fast flow paths and how to minimize the flow of the fast paths....
Comparison of Predicted Far-Field Temperatures for Discrete and Smeared Heat Sources
A fundamental concern in the design of the potential repository at Yucca Mountain, Nevada is the response of the host rock to the emplacement of heat-generating waste. The thermal perturbation...
Field Investigation of Mining-Induced Seismicity on Local Geohydrology
Hydraulic response of the rock mass due to earthquakes is one of the concerns in the assessment of the long-term performance of a repository. Studies performed by other researchers indicated...
Influence of Deterministic Geologic Trends on Spatial Variability of Hydrologic Properties in Volcanic Tuff
Hydrologic properties have been measured on outcrop samples taken from a detailed, two-dimensional grid covering a 1.4 km outcrop exposure of the 10-m thick nonwelded-to-welded, shardy...
Rock Mass Mechanical Property Estimation Strategy for the Yucca Mountain Site Characterization Project
Rock mass mechanical properties are required in the design of repository drifts and ramps to assess the impact of thermal loads from the heat-generating wastes on excavation performance...
Estimation of Water-Filled and Air-Filled Porosity in the Unsaturated Zone, Yucca Mountain, Nevada
The responses of density and dielectric logs are formulated in terms if the matrix properties, air-filled porosity and water-filled porosity. Porosity values obtained from logs from borehole...
Single-Hole in Situ Thermal Probe for Hydrothermal Characterization at Yucca Mountain
The REKA thermal probe method, which uses a single borehole to measure in situ rock thermophysical properties and provides for efficient and low-cost site characterization, is analyzed...
Scale Dependence of Effective Media Properties
For problems where media properties are measured at one scale and applied at another, scaling laws or models must be used in order to define effective properties at the scale of interest....
Full-Field Dye Concentration Measurement Within Saturated/Unsaturated Thin Slabs of Porous Media
This paper presents a full-field dye concentration measurement technique that extends our experimental capabilities to the measurement of transient dye concentration fields within steady...
Effect of Interconnection of Fractures on Dispersion in Flow Through Fractured Networks
A stochastic modeling technique in a 2-D discrete fracture network with two orthogonal sets of fractures is developed to investigate mass transport dispersion and to investigate the relation...
Modeling Storage Behavior in a Fractured Rock Mass
To represent single bore hole injection tests in fractured rock masses, a transient model has been implemented, based on a three dimensional stochastic description of the fracture network....
Connectivity and the Continuum Approximation in Fracture Flow Modeling
The continuum assumption is frequently made when modeling flow in fractured media. The approach presented in this paper helps evaluating the validity of such an assumption. Two indices...
Modeling of Fluid and Solute Transport in Fractured Rock
A new model for flow and solute transport in fractured rock is proposed. It is based on the concept of a network of channels. The individual channel members are given stochastically selected...
Channel Network Models for Solute Migration and Dispersal
We introduce a class of channel-network models for solute migration and dispersal in saturated rock. In discussing the behaviour of any dispersive process it is necessary to compare and...
Return to search